Time to get the pilot house situated.
The settee was too uncomfortable because of the back rest. So I had to glue a plywood backrest on to the foam, then build a stop for it so we have a little angle to lean against. This is the angle I finished with.	Here is the stop. Just a bit of molding set on the curve of the settee.
When sizing up the foam for the settee one side was too short. So I made a ledge for the foam to sit on so the foam is rectangular 76" by 18".	Everything in place ready for the table. Note the start of the fancy work.
All done, leveled and ready to drink beer..	Here the coat rack to hang our wet stuff next to the heater.